Make sure the charging cable is fully inserted into the charging port. Sometimes, the charging port pin may become misaligned when forcefully inserting the charging cable. To realign the charging pin, use a non-conductive tool. Depending on the battery type, an extended charging period is needed once the battery has been fully drained.

Purchasing replacement parts

You can purchase them at eureka.encompass.com.

It depends on the type of filter. Cloth or fabric intake filters should be cleaned regularly and changed once every 3-6 months. HEPA or exhaust filters should be changed once per year and checked regularly. Always check the filter to make sure there are no holes or tears in the intake filters. Any types of tears will greatly reduce the lifespan of your vacuum cleaner.

There are a few things that might cause your vacuum to have a low suction.

Please try the steps below:

1. Check The Brush Roll.

Check if the brush roll is spinning on the unit. You can tilt the vacuum to the side while it's in use by locking it in an upright position and rotating the unit down until the handle touches the floor. If the brush roll is not spinning turn the vacuum off and unplug it from the wall.  

You may also try turning the brush roll by hand. If the brush roll is stuck, make sure no debris or hair is clogging the brush roll. If the brush roll turns freely, the belt may need to be replaced. Most vacuum cleaners have belts that require replacing after extended use.

2. Check The Filter.

Check the filter to see if it needs to be cleaned or replaced. Using the vacuum without a filter will cause serious damage to the internal components of the unit.

3. Check The Hoses For Clogs.

You can do this by locating the connection points of the hose to the vacuum to find large clogs. Try to compress the hose and look for any areas in the hose that will not compress. 

Sometimes dirt or hair will get built up in these hoses. You can also try to shake the debris-free or use a dull object to dislodge the debris as an alternative method.

You can check your brush roll by tilting the vacuum to the side during use by locking in an upright position and rotating the unit down until the handle touches the floor. If it is not spinning, turn the vacuum off and unplug from the wall. Try turning the brush roll by hand. If it is stuck, make sure there is no debris or hair clogging the brush roll. If the brush roll turns freely, the belt may need to be replaced. Most vacuum cleaners have belts that require replacing after extended use.

Maintenance And Care - Cleaning Dust Cup Filter

1. Open the dust cup filter lid, located on the top of the cup.
2. Remove the dust cup foam filter.
3. Hand wash the foam filter
4. Allow filter to dry 24 hours before putting back into the vacuum cleaner.

TheEureka Robot app is available from the App Store for Apple devices, and the Google Play Store for Android devices.

Click your devices option below:


iOS/Apple App Store

Google Play

Yes. Once connected to theEureka Robot app, you can connect the app to either Google Home or Alexa through their respective apps. Once connected, the vacuum will respond to voice commands.

Click to download the Eureka Robot app for your smarthphone.

iOS/Apple App Store

Android/Google Plat Store

No. You do not need to connect your phone to the robot vacuum. However, to get the most functionality out of the unit, you will need to connect the app to the vacuum. This will give you access to scheduling, current operation status and alerts.